2013 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE

Accessory Protocol Interface Module (APIM) Programming - Module Replacement

SPECIAL TOOLS DESCRIPTION

G06139341Courtesy of FORD MOTOR CO.
Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool
G07399246Courtesy of FORD MOTOR CO.
SYNC® Re-Flash Kit
CCMSYNC-KIT or equivalent
(Tools are also available individually CCMUSB2-AM-AM-10 [cable] and CCMUSB-AF-BF5 [adapter])
NOTE: Use this procedure to program and provision the module when a new Accessory Protocol Interface Module (APIM) is being installed. For additional information on choosing the correct programming procedure, refer to Information and Entertainment System , APIM PROGRAMMING.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.