Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford Mustang Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE
Module Communications Network DTCS
COMMUNICATION NETWORK DTC CHART
| DTC | Description | Action |
|---|---|---|
| U0001:88 | High Speed CAN Communication Bus: Bus Off | The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). CLEAR the DTC. REPEAT the Network Test with the scan tool. VERIFY the integrity of the connectors and wiring Refer to SYSTEM WIRING DIAGRAMS , Module Communications Network for additional information. |
| U0028:08 | Vehicle Communication Bus A: Bus Signal / Message Failure | The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). CLEAR the DTC. REPEAT the Network Test with the scan tool. VERIFY the integrity of the connectors and wiring Refer to SYSTEM WIRING DIAGRAMS , Module Communications Network for additional information. |
| U0028:88 | Vehicle Communication Bus A: Bus off | The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). CLEAR the DTC. REPEAT the Network Test with the scan tool. VERIFY the integrity of the connectors and wiring Refer to SYSTEM WIRING DIAGRAMS , Module Communications Network for additional information. |
| U0073 | Control Module Communication Bus Off | The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). CLEAR the DTC. REPEAT the Network Test with the scan tool. VERIFY the integrity of the connectors and wiring Refer to SYSTEM WIRING DIAGRAMS , Module Communications Network for additional information. |
| U2472 | Unexpected Ignition State | This DTC is only set when an on-demand self-test is run with the test entry conditions not correct. CLEAR the DTC. REPEAT the self-test with the ignition in the ON position and the vehicle stationary. |
| U2473 | Unexpected Vehicle Speed | This DTC is only set when an on-demand self-test is run with the test entry conditions not correct. CLEAR the DTC. REPEAT the self-test with the ignition in the ON position and the vehicle stationary. |
| - | All network DTCs referenced to this service information from another information | GO to SYMPTOM CHART . |
| - | All other DTCs | REFER to MULTIFUNCTION ELECTRONIC MODULES . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.