Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford Fusion Energi TitaniumFACTORY OEM SERVICE PROCEDURE
Module Configuration and Parameter Chart
WARNING: This page is about a different variant/trim than selected.
The chart describes specific module configuration information:
| Module Name | Programmable Module Installation (PMI) Available | Reprogram/Flash Capable | Requires Adaptive Learning or Calibration | Available Progammable Parameters |
|---|---|---|---|---|
| APIMÂ | Yes | Yes | No | None |
| ABSÂ module | Yes | Yes |
|
None |
| ACMÂ | Yes | Yes | No |
|
| BCMÂ | Yes | Yes |
|
|
| CCMÂ | Yes | Yes | No | None |
| DSPÂ | Yes | Yes | No | None |
| DCÂ /DCÂ Converter Control Module (Voltage Quality Module) | Yes | Yes | No | None |
| DDMÂ | Yes | Yes | No | None |
| DSMÂ | Yes | Yes | No | None |
| FCIMÂ | Yes | Yes | No | None |
| FCDIMÂ (4.2-inch screen) | Yes | Yes | No | None |
| GWMÂ | Yes | Yes | No | None |
| GPSMÂ | Yes | Yes | No | None |
| HUDÂ Module | No | No | No | None |
| IPMAÂ | Yes | Yes |
|
None |
| IPCÂ | Yes | Yes | No |
|
| OCSMÂ | No | No |
|
None |
| PAMÂ (integrated with BCMÂ ) | Yes | Yes | No | None |
| PSCMÂ | Yes | Yes | No | None |
| PCMÂ | No | Yes | No | None |
| PDMÂ | Yes | Yes | No | None |
| RTMÂ | Yes | Yes | No | None |
| RCMÂ | Yes | Yes | No | None |
| SODLÂ | Yes | Yes | No |
|
| SODRÂ | Yes | Yes | No |
|
| SCCMÂ | Yes | Yes | No | None |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
