WARNING: This page is about a different car, the 2016 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

The charts describe specific module configuration information:

All Modules Except BCM and IPC

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Programmable Parameters
AWD module	703	Yes	No	ATC bleed procedure	None
APIM Premium Audio	7D0	Yes	Yes	No	None
APIM Sony®	7D0	Yes	Yes	No	Surround sound Navigation repeater format
ABS module	760	No	No	IVD initialization	Tire size
ACM	727	Yes	Yes	No	Radio presets
DACMC	7D5	Yes	Yes	No	None
DSP	783	Yes	Yes	No	None
DDM	740	No	No	No	None
FCIM	7A7	No	No	No	None
FCDIM	7A5	Yes	Yes	No	None
GFM2	7D2	No	No	No	None
GPSM (if equipped)	701	Yes	Yes	No	None
HCM	734	Yes	Yes	No	None
HVAC module	733	No	No	No	None
IPMA	706	Yes	Yes	Camera calibration	None
ICM (if equipped)	784	No	No	No	None
OCSM	765	No	No	OCS re-zero	None
PAM	736	Yes	Yes	No	None
PSCM	730	No	No	No	None
PCM	7E0	Yes	Yes	Yes	Speed control present VIN
PDM	741	No	No	No	None
RFA module	731	Yes	No	PATS parameter reset	Passive entry/passive start (PEPS)
RCM	737	Yes	Yes	No	None
SODL	7C4	No	Yes	No	None
SODR	7C6	No	Yes	No	None
SASM	797	No	No	No	None
TCM	7E1	Yes	Yes	Yes	None

Body Control Module (BCM) and Instrument Panel Cluster (IPC)

NOTE: The Body Control Module (BCM) and IPC have a unique procedure to set Car Configuration Parameters. Configuration changes made will affect both modules. On the scan tool, first select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Retrieve the Vehicle Configuration Data. Next select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Modify and Reinstate Vehicle Configuration Data. Change parameters as needed.

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Car Configuration Parameters
BCM	726	Yes (through Car Configuration Parameters. Refer to Body Control Module (BCM)	Yes	No	NOTE: Do not change car configuration parameters except those listed below. Daytime running lamps (DRL) enable/disableSeat belt warning (Belt-Minder®)English/MetricLanguageRear reverse gear wipeCourtesy wipe disable
IPC	720	Yes	Yes	No

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic