Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford Focus STFACTORY OEM SERVICE PROCEDURE
Front Control Display Interface Module (FCDIM) DTC Table
FRONT CONTROL DISPLAY INTERFACE MODULE (FCDIM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | GO to Pinpoint Test S |
| All other Diagnostic Trouble Codes (DTCs) | - | Refer to the appropriate INFORMATION AND ENTERTAINMENT SYSTEM - GENERAL INFORMATION - AM/FM/CD , INFORMATION AND ENTERTAINMENT SYSTEM - GENERAL INFORMATION - AM/FM/CD/SYNC or INFORMATION AND ENTERTAINMENT SYSTEM - GENERAL INFORMATION - SYNC/SONY AM/FM/CD article for the procedure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.