2013 Ford Focus S, Standard Trans, GasFACTORY OEM SERVICE PROCEDURE

Quick Lookups: Fluids

FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil Gas 5.10 OZS. 0.15 L PAG 46 S
Air Cond Refrigerant 1.32 LBS. 0.59 KG R-134a S
Brake Fluid S,SE,ST,Titanium N/A N/A MOTORCRAFT High Performance DOT 4 Motor Vehicle Brake Fluid Fill between "max" and "min" lines on reservoir. S
Engine Coolant S,SE,ST,Titanium 5.30 QTS. 5.01 L MOTORCRAFT Orange Antifreeze/Coolant Prediluted Add the coolant type originally equipped in the vehicle. S
Engine Oil Normally Aspirated 4.50 QTS. 4.25 L MOTORCRAFT SAE 5W-20 Premium Synthetic Blend Motor Oil or MOTORCRAFT SAE 5W-20 Full Synthetic Motor Oil. Use of synthetic or synthetic blend motor oil is not mandatory. Engine oil need only meet the requirements of Ford specification WSS-M2C945-A, SAE 5W-20 and display the API Certification Mark. Your engine has been designed to be used with Ford engine oil, which gives a fuel economy benefit while maintaining the durability of your engine. Using oils other than the one specified can result in longer engine cranking periods, reduced engine performance, reduced fuel economy and increased emission levels. S
Fuel Tank 12.40 GALS. 46.93 L S
Manual Transmission Fluid 2.01 QTS. 1.9 L MOTORCRAFT Dual Clutch Transmission Fluid XT-11-QDC Approximate dry fill capacity. Actual amount may vary during fluid changes. S
Windshield Washer Fluid N/A N/A MOTORCRAFT Premium Windshield Washer Concentrate Fluid Follow the Manufacturer's Instructions for the mixture ratio. S
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.