Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford Fiesta Titanium, 4D Hatchback, Standard TransFACTORY OEM SERVICE PROCEDURE
Steering System DTC
DTC INDEX
| DTC | Description |
|---|---|
| DTC B1304 | Electronic Power Assisted Steering System |
| DTC B1D23 | Overheat Sensor |
| DTC C1023 | Pull Drift Compensation Limit Exceeded |
| DTC C102D | High Friction Inside Power Steering |
| DTC P07AE | Transmission Friction Element G Performance/Stuck Off |
| DTC U0126 | Lost Communication With Steering Angle Sensor Module |
| DTC U0140 | Lost Communication With Body Control Module |
| DTC U0151 | Lost Communication With Restraints Control Module |
| DTC U0159 | Lost Communication With Parking Assist Control Module A |
| DTC U0422 | Invalid Data Received from Body Control Module |
| DTC U0423 | Invalid Data Received from IPC |
| DTC U0428 | Invalid Data Received from the Steering Angle Sensor Module |
| DTC U0452 | Invalid Data Received From RCM |
| DTC U045A | Invalid Data Received From Parking Assist Control Module A |
| DTC U3000 | Control Module - Signal Calculation Failure and Component Internal Failure |
| DTC U3000 | Control Module - Actuator Stuck Open |
| DTC C1B00 | Steering Angle Sensor - Signal Erratic |
| DTC U3003 | Steering Column Mounted EPAS - Battery Voltage - Circuit Voltage Below Threshold and Circuit Voltage Above Threshold |
| DTC C100C | Steering Column Mounted EPAS - Steering Tracking |
| DTC C1023 | Steering Tracking |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
