Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford F-150 Limited, RWDFACTORY OEM SERVICE PROCEDURE
Module Communications Network DTCS
COMMUNICATION NETWORK DTC CHART
| DTC | Description | Source | Action |
|---|---|---|---|
| U0001:88 | High Speed CAN Communication Bus: Bus off | Power Steering Control Module (PSCM) | The module could not communicate on the network at a point in time. The fault is currently not present since the module is currently communicating with the scan tool reporting this DTC. CLEAR the DTC. REPEAT the network test with the scan tool. VERIFY the integrity of the connectors and wiring. Refer to SYSTEM WIRING DIAGRAMS - Module Communications Network for schematic and connector information. |
| U0028:08 | Vehicle Communication Bus A: Bus Signal / Message Failures | Restraints Control Module (RCM) | The module could not communicate on the network at a point in time. The fault is currently not present since the module is currently communicating with the scan tool reporting this DTC. CLEAR the DTC. REPEAT the network test with the scan tool. VERIFY the integrity of the connectors and wiring. Refer to SYSTEM WIRING DIAGRAMS - Module Communications Network for schematic and connector information. |
| U0028:88 | Vehicle Communication Bus A: Bus Off | Restraints Control Module (RCM) | The module could not communicate on the network at a point in time. The fault is currently not present since the module is currently communicating with the scan tool reporting this DTC. CLEAR the DTC. REPEAT the network test with the scan tool. VERIFY the integrity of the connectors and wiring. Refer to SYSTEM WIRING DIAGRAMS - Module Communications Network for schematic and connector information. |
| U0073 | Vehicle Communication Bus A "Off" | ABS module | The module could not communicate on the network at a point in time. The fault is currently not present since the module is currently communicating with the scan tool reporting this DTC. CLEAR the DTC. REPEAT the network test with the scan tool. VERIFY the integrity of the connectors and wiring. Refer to SYSTEM WIRING DIAGRAMS - Module Communications Network for schematic and connector information. |
| U1900 | CAN Communication Bus Fault - Receive Error | Power Running Board (PRB) module | CARRY out the network test. GO to SYMPTOM CHART for the module that fails the network test. |
| U3000:88 | Control Module: Bus Off | Accessory Protocol Interface Module (APIM) | The module could not communicate on the network at a point in time. The fault is currently not present since the module is currently communicating with the scan tool reporting this DTC. CLEAR the DTC. REPEAT the network test with the scan tool. VERIFY the integrity of the connectors and wiring. Refer to SYSTEM WIRING DIAGRAMS - Module Communications Network for schematic and connector information. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
