2013 Ford F-150 Limited, RWDFACTORY OEM SERVICE PROCEDURE

Body Control Module (BCM)

BODY CONTROL MODULE (BCM) DTC CHART

DTC Description Action
B10D5:13 PATS Antenna: Circuit Open The Body Control Module (BCM) received an incomplete or corrupt response from the transceiver. INSTALL a new transceiver. REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) TRANSCEIVER .
B10D7:05 PATS Key: System Programming Failure GO to PINPOINT TEST A .
B10D7:51 PATS Key: Not Programmed There is an unprogrammed Passive Anti-Theft System (PATS) key. PROGRAM the PATS key. REFER to KEY PROGRAMMING - PROGRAM A KEY USING TWO PROGRAMMED KEYS or KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
B10D7:55 PATS Key: Not Configured
NOTE: Once the BCM Programmable Module Installation (PMI) is complete, follow the scan tool on-screen instructions for carrying out the Configurable Engine Immobilizer (CEI) Lock Configuration.
The BCM (CEI) was not configured after Programmable Module Installation (PMI). CARRY OUT the BCM PMI. REFER to MODULE CONFIGURATION SYSTEM .
B10D7:87 PATS Key: Missing Message GO to PINPOINT TEST B .
B10D7:8F PATS Key: Erratic GO to PINPOINT TEST B .
B10D8:00 PATS Key Less Than Minimum Programmed: No Sub Type Information Less than 2 keys are programmed into the BCM. CYCLE the customer's second key in the ignition to program (when less than 2 keys are programmed, the BCM automatically programs the first 2 keys that are cycled in the ignition).
B10D9:87 PATS Transponder: Missing Message GO to PINPOINT TEST C .
B10DA:51 PATS Target Identifier: Not Programmed There is no PCM ID stored in the BCM. CARRY OUT a parameter reset. REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET . CLEAR the DTCs. REPEAT the self-test.
C113A:11 Wakeup Control: Circuit Short to Ground GO to PINPOINT TEST D .
C113A:15 Wakeup Control: Circuit Short to Battery or Open GO to PINPOINT TEST D .
U1000:00 Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test.
All other DTCs - REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.