Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2013EXPLORER POLICE INTERCEPTOR, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXSIDE AND REAR VISIONSOD-L AND SOD-R
2013 Ford Explorer Police Interceptor, AWD
Sod-L And Sod-R
2013 Ford Explorer Police Interceptor, AWDSECTION Sod-L And Sod-R
DTC DESCRIPTION - SOD-L AND SOD-R
| DTC | Description | Action |
|---|---|---|
| B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | GO to PINPOINT TEST D . |
| B11D6:15 | Driver Display Alert LED: Circuit Short To Battery Or Open | GO to PINPOINT TEST D . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to PINPOINT TEST J . |
| U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | This DTC sets when the SOD-L or SOD-R receive invalid network data from the BCM with a faulted signal data input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or improper PMI procedures. If there have been recent service actions with this module, REPEAT the PMI procedure as directed by the scan tool (REFER to MODULE CONFIGURATION , PMI for further information). If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. |
| U3000:44 | Control Module: Data Failure | GO to PINPOINT TEST H . |
| U3000:45 | Control Module: Program Memory Failure | GO to PINPOINT TEST H . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | GO to PINPOINT TEST H . |
| U3000:48 | Control Module: Supervision Software Failure | GO to PINPOINT TEST H . |
| U3000:49 | Control Module: Internal Electronic Failure | GO to PINPOINT TEST H . |
| U3000:4A | Control Module: Incorrect Component Installed | GO to PINPOINT TEST H . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.