2013 Ford Escape Titanium, FWDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Catalytic converter manifold heat shield bolts (2.5L) 10 - 89
Catalytic converter manifold nuts (2.5L) 55 41 -
Catalytic converter manifold studs (2.5L) 17 - 150
Catalytic converter-to-exhaust bracket bolts (2.5L) 25 18 -
Catalytic converter-to-exhaust bracket nuts (1.6L GTDI) 25 18 -
Catalytic converter-to-exhaust bracket nuts (2.0L GTDI)(1) - - -
Catalytic converter-to-muffler and tailpipe nuts 48 35 -
Catalytic converter-to-turbocharger clamp (2.0L Gasoline Turbocharged Direct Injection (GTDI)) 20 - 177
Catalytic converter-to-turbocharger nuts (1.6L Gasoline Turbocharged Direct Injection (GTDI))(1) - - -
Crossbrace nuts and bolts 20 - 177
Exhaust bracket-to-transmission nuts (1.6L GTDI and 2.0L GTDI) 25 18 -
Exhaust support bracket-to-front subframe bolts 25 18 -
Service clamp nuts 48 35 -
Worm gear clamp 7 - 62
(1) Refer to the appropriate procedure in this information.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.