WARNING: This page is about a different car, the 2014 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The Body Control Module (BCM) and IPC have a unique procedure to set Car Configuration Parameters. Configuration changes made will affect both modules. On the scan tool, first select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Retrieve the Vehicle Configuration Data. Next select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Modify and Reinstate Vehicle Configuration Data. Change parameters as needed.

Module Name	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Car Configuration Parameters
BCM	Yes (through Car Configuration Parameters. Refer to MULTIFUNCTION ELECTRONIC MODULES -- ESCAPE .	Yes	No	NOTE: Do not change car configuration parameters except those listed below. Courtesy wipe disable BLIS® enable/disable Loud speaker quantities (6, 9 or 10) Language Park assist camera Remote start enable/disable Tire size Towbar Trailer module Trailer stability assist
IPC	Yes	Yes	No

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Body Control Module (BCM) and Instrument Panel Cluster (IPC)

Use the Manual With the Right Hardware

When to See a Mechanic