Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford Escape SFACTORY OEM SERVICE PROCEDURE
Network Message Chart
MODULE NETWORK INPUT MESSAGES - BCM
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Alternator fault | PCM | The PCM has detected a fault in the generator or generator circuits. |
MODULE NETWORK INPUT MESSAGES - IPC
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Power system status | BCM | Reports any generator/charging system faults. Used for charging system fault indicator. |
MODULE NETWORK INPUT MESSAGES - PCM
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Vehicle speed | ABS module | Vehicle speed is reported via HS-CAN. Used by the PCM during charging system voltage calculation. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
