Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford C-Max SEFACTORY OEM SERVICE PROCEDURE
Transmission Fluid Level Check: Check
WARNING:
Before beginning any service procedure, refer to HEALTH AND SAFETY PRECAUTIONS
. Failure to follow this instruction may result in serious personal injury.
- Refer to: HEALTH AND SAFETY PRECAUTIONS .
- Start the engine and allow to run for 1 minute. Turn engine off and wait 5 minutes.
- Refer to: JACKING AND LIFTING - OVERVIEW .
- The transmission fluid should be even with the bottom of the oil leveling plug hole.
- If the transmission fluid is not even with the oil leveling plug hole, add clean transmission fluid.
Material: Motorcraft® MERCON® LV Automatic Transmission Fluid / XT-10-QLVC (WSS-M2C938-A) (MERCON® LV)
- Torque:
8 Nm
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.