2013 Ford C-Max EnergiFACTORY OEM SERVICE PROCEDURE

Steering System DTCS

DTC INDEX

DTC Description
DTC C1023: PULL DRIFT COMPENSATION LIMIT EXCEEDED Pull Drift Compensation Limit Exceeded
DTC C102D: HIGH FRICTION INSIDE POWER STEERING High Friction Inside Power Steering
DTC U0001: HIGH SPEED CAN COMMUNICATIONS BUS High Speed CAN Communications Bus
DTC U0100: LOST COMMUNICATION WITH ECM/PCM A Lost Communication with ECM/PCM A
DTC U0126: LOST COMMUNICATION WITH STEERING ANGLE SENSOR MODULE Lost Communication With Steering Angle Sensor Module
DTC U0140: LOST COMMUNICATION WITH BODY CONTROL MODULE Lost Communication With Body Control Module
DTC U0159: LOST COMMUNICATION WITH PARKING ASSIST CONTROL MODULE A Lost Communication With Parking Assist Control Module A
DTC U0300: INTERNAL CONTROL MODULE SOFTWARE INCOMPATIBILITY Internal Control Module Software Incompatibility
DTC U0415: INVALID DATA RECEIVED FROM ABS CONTROL MODULE Invalid Data Received from ABS Control Module
DTC U0422: INVALID DATA RECEIVED FROM BODY CONTROL MODULE Invalid Data Received from Body Control Module
DTC U0428: INVALID DATA RECEIVED FROM THE STEERING ANGLE SENSOR MODULE Invalid Data Received from the Steering Angle Sensor Module
DTC U045A: INVALID DATA RECEIVED FROM PARKING ASSIST CONTROL MODULE A Invalid Data Received From Parking Assist Control Module A
DTC U2100: INITIAL CONFIGURATION NOT COMPLETE Initial Configuration Not Complete
DTC U2101: CONTROL MODULE CONFIGURATION INCOMPATIBLE Control Module Configuration Incompatible
DTC U3000: CONTROL MODULE Control Module
DTC U3003: BATTERY VOLTAGE Battery Voltage
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.