Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford C-Max EnergiFACTORY OEM SERVICE PROCEDURE
RFA Module
| DTC | Description | Action |
|---|---|---|
| B102B:00 | Passive Key: No Sub Type Information | GO to PINPOINT TEST G |
| B102B:05 | Passive Key: System Programming Failure | Less than 2 keys are programmed. PROGRAM additional keys (a minimum of 2 keys must be programmed). REFER to: KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT (419-01C Passive Anti-Theft System (PATS) - Vehicles With: Push Button Start, General Procedures). |
| B10C7:1F | Interior Trunk Antenna: Circuit Intermittent | GO to PINPOINT TEST A |
| B10C8:1F | Interior Centre Antenna: Circuit Intermittent | GO to PINPOINT TEST A |
| B10C9:1F | Interior Front Antenna: Circuit Intermittent | GO to PINPOINT TEST A |
| B11CC:51 | Immobilizer Keyless Vehicle Secret Key: Not Programmed | There is no BCM
ID stored in the RFA
module. CARRY OUT a parameter reset. REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET (419-01C Passive Anti-Theft System (PATS) - Vehicles With: Push Button Start, General Procedures). |
| B1399:00 | Personalised Key Synchronisation: No Sub Type Information | ERASE and PROGRAM all of the customer's keys. REFER to: ERASE ALL KEYS AND KEY PROGRAMMING (419-01C Passive Anti-Theft System (PATS) - Vehicles With: Push Button Start, General Procedures). |
| U201F:00 | External Receiver: No Sub Type Information | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| U201F:13 | External Receiver: Circuit Open | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| U201F:87 | External Receiver: Missing Message | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| All other DTCs | - | REFER to: REMOTE FUNCTION ACTUATOR (RFA) MODULE (419-10 Multifunction Electronic Modules, Diagnosis and Testing). |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
