2013 Ford C-Max Energi SELFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module (Pcm)

DTC Description Action
PCM DTCs Powertrain Control Module Diagnostic Trouble Codes (DTCs) not listed in this chart Refer to ENGINE CONTROLS - INTRODUCTION (HYBRID) .
P0072 Ambient Air Temperature Sensor Circuit "A" Low Refer to ENGINE CONTROLS - INTRODUCTION (HYBRID) .
P0073 Ambient Air Temperature Sensor Circuit "A" HIGH Refer to ENGINE CONTROLS - INTRODUCTION (HYBRID) .
P0532 A/C Refrigerant Pressure Sensor "A" Circuit Low GO to PINPOINT TEST A
P0533 A/C Refrigerant Pressure Sensor "A" Circuit High GO to PINPOINT TEST A
P2184 Engine Coolant Temperature Sensor 2 Circuit Low GO to PINPOINT TEST W
P2185 Engine Coolant Temperature Sensor 2 Circuit High GO to PINPOINT TEST W
P2186 Engine Coolant Temperature Sensor 2 Circuit Intermittent/Erratic GO to PINPOINT TEST W
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.