Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE
Windshield: Service and Repair
Glass Reseal - Windshield
1. Remove the cowl panel grilles.
2. Remove the headliner.
3. Clean the interior and exterior of the windshield glass surface with glass cleaner.
4. Cut the urethane adhesive applicator tip to the specification.
5. NOTE: Use either the Air Caulking Gun or a high ratio, electric or battery-operated caulk gun that will apply the urethane adhesive with less effort and a continuous bead.
NOTE: Make sure there are no gaps in the urethane adhesive bead.
Apply urethane adhesive over the top of the existing urethane adhesive.
- Apply the urethane adhesive to the top and sides of the windshield from the interior of the vehicle.
- Apply the urethane adhesive to the bottom of the windshield from the exterior of the vehicle.
6. NOTE: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.
After the urethane adhesive has cured, check the windshield seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as necessary.
7. Install the headliner.
8. Install the cowl panel grille.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
