Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE
Repair and Diagnosis: Technical Service Bulletins
- How to Find Technical Service Bulletins by Category/Symptom
- Recalls
- Customer Interest
- Lighting - Front Turn Signal Lamp(s) Are Inoperative
- Electrical - Low Power/Runs Rough/Misfire DTC's
- Engine Controls - MIL ON/DTC P0351 Or P0354/Runs Rough
- Engine Controls - MIL ON/DTC P0403 Set
- A/T - Shift Flare/No 3rd/4th Gear/Multiple DTC's Set
- Engine Controls/Cooling Sys - Overheating/Poor A/C Perf.
- Engine - Oil Filter Leaks/Oil Filter Housing Distorted
- Engine Controls - MIL ON/Multiple DTC's Set
- Wipers/Washers - Poor Windshield Wiper Performance
- A/C - Blower Motor Inop/Water Leaks Onto Front Floor
- Engine, A/T - Vibration at Idle/Reverse
- Superceded Bulletins
- All Technical Service Bulletins
- Lighting - Front Turn Signal Lamp(s) Are Inoperative
- Electrical - Low Power/Runs Rough/Misfire DTC's
- Engine Controls - MIL ON/DTC P0351 Or P0354/Runs Rough
- Engine Controls - MIL ON/DTC P0403 Set
- A/T - Shift Flare/No 3rd/4th Gear/Multiple DTC's Set
- Engine Controls/Cooling Sys - Overheating/Poor A/C Perf.
- Engine - Oil Filter Leaks/Oil Filter Housing Distorted
- Engine Controls - MIL ON/Multiple DTC's Set
- Recall - Wiper Arm Replacement
- Wipers/Washers - Poor Windshield Wiper Performance
- A/C - Blower Motor Inop/Water Leaks Onto Front Floor
- Engine, A/T - Vibration at Idle/Reverse
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
