Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE
Pinpoint Tests
Pinpoint Test
Pinpoint Test A: Battery Condition Test
Normal Operation
Battery condition is determined by measuring battery terminal voltage after a specific discharge current is applied for a specified time period.
This pinpoint test is intended to diagnose the following:
- Battery charge
- Battery
PINPOINT TEST A : BATTERY CONDITION TEST
A1 TEST THE BATTERY CONDITION
NOTE: A red test-eye indicates the battery is discharged, not necessarily defective.
NOTE: Failure to fully charge the battery before retesting may cause false readings.
- Verify the battery condition using the Intelligent Diagnostic Charger.
Is the battery OK?
Yes
RETURN the battery to service.
No
If the analyzer reads REPLACE BATTERY or REPLACE-BAD CELL, INSTALL a new battery. REFER to Battery .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
