2012 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE

Oil Pressure Sensor: Service and Repair




Engine Oil Pressure (EOP) Switch

Factory service manual diagram




Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.

3. Remove the EOP (Engine Oil Pressure) switch.
- To install, tighten to 15 Nm (133 lb-in).


4. NOTE: Apply thread sealant to the EOP (Engine Oil Pressure) switch threads.
To install, reverse the removal procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.