2012 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE

Inspection and Verification




Module Configuration

Inspection and Verification

This system provides step-by-step module configuration procedures. Carry out Programmable Module Installation (PMI) when another diagnostic/repair information directs to carry out configuration or when DTCs from the list below are present Programmable Module Installation (PMI)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.