2012 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE

Fluid - A/T: Service and Repair




Transmission Fluid Exchange

Factory service manual diagram




Factory service manual diagram




NOTICE: Use transmission fluid specific for this transmission. Do not use any supplemental transmission fluid additives or cleaning agents. The use of these products can cause internal transmission components to fail, which will affect the operation of the transmission.

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Use the Heavy-Duty Transmission and Power Steering Fluid X-Changer to change the fluid.

3. Connect the Heavy-Duty Transmission and Power Steering Fluid X-Changer to the transmission fluid cooler tube after the transmission fluid cooler on the return tube. This will help remove any foreign material trapped in the transmission fluid coolers.

4. Perform the transmission fluid exchange using the Heavy-Duty Transmission and Power Steering Fluid X-Changer. Follow the manufacturer's instructions included with the machine.

5. Once the transmission fluid exchange is completed, disconnect the Heavy-Duty Transmission and Power Steering Fluid X-Changer. Reconnect any disconnected transmission fluid cooler tubes.

6. Using the scan tool with the engine running, check and make sure that the transmission is at normal operating temperature 49°C-60°C (120°F-140°F). Check and adjust the transmission fluid level and check for any leaks. If transmission fluid is needed, add transmission fluid in increments of 0.24L (0.5 pt) until the correct level is achieved.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.