2012 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE

Heater Core: Service and Repair




Heater Core

Factory service manual diagram




Factory service manual diagram





Factory service manual diagram




Factory service manual diagram





Factory service manual diagram




Factory service manual diagram




Removal and Installation

NOTE: If a heater core leak is suspected, the heater core must be leak tested before it is removed from the vehicle.

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Drain the engine coolant.

3. Remove the floor console.

4. Remove the RH lower instrument panel insulator.

5. Remove the screw and the floor duct.

Factory service manual diagram




6. Release the 2 heater hose clamps and disconnect the heater hoses from the heater core.

7. Remove the 6 in-vehicle crossbeam bracket bolts and remove the brackets (RH shown).
- To install, tighten to 25 Nm (18 lb-ft).


Factory service manual diagram




8. Remove the LH floor duct clip between the heater core and evaporator core housing and the dash panel.

Factory service manual diagram




9. Remove the LH floor duct.
1. Remove the LH floor duct clip

2. Remove the LH floor duct screw.
- Remove the LH floor duct.


Factory service manual diagram




10. Remove the RH floor duct.
1. Remove the RH floor duct clip.

2. Remove the RH floor duct screw.
- Remove the RH floor duct.


Factory service manual diagram




11. Remove the heater core cover.
1. Remove the 2 heater core cover screws.

2. Remove the 2 heater core cover clips.

3. Release the heater core cover tab and remove the heater core cover and heater core as an assembly.


Factory service manual diagram




12. Remove the heater core tube bracket screw.

Factory service manual diagram




13. Remove the heater core.

14. To install, reverse the removal procedure.

15. Fill the engine coolant level.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.