Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE
Cruise Control: Description and Operation
Cruise Control
The cruise control system consists of the following components:
- Electronically-controlled throttle body
- Cruise control deactivator switch (part of the stoplamp switch)
- Cruise control indicator
- Cruise control switch(es)
- Stoplamp switch
- PCM
When the cruise control system is activated, a selected vehicle speed above 40 km/h (25 mph) to the maximum limited vehicle speed can be maintained without pressing the accelerator pedal. The cruise control system is controlled by the steering wheel mounted switches (ON, OFF, SET+, - and RES), and the brake pedal. The steering wheel mounted switches are hardwired to the PCM.
During normal driving, the vehicle speed may vary slightly from the set speed due to road conditions. The vehicle speed may vary or fluctuate when driving up and down a steep hill. If the vehicle speed decreases more than 16 km/h (10 mph) below the set speed, the cruise control disengages.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
