Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE
Front Fender: Service and Repair
Fender
Removal and Installation
All vehicles
1. With the vehicle in neutral, position it on a hoist.
2. Remove the front bumper cover.
3. Remove the fender moulding.
4. Remove the fender splash shield. For additional information, refer to Fender Splash Shield Fender Splash Shield.
5. Remove the cowl panel grille. For additional information, refer to Cowl Panel Grille .
Driver side
6. Remove the windshield washer bottle.
All vehicles
7. Loosen the rear fender nut.
- To install, tighten to 7 Nm (62 lb-in).
8. Disconnect the turn signal electrical connector.
9. Pull outward to release the mirror trim panel from the vehicle.
10. Remove the 2 front fender front bolts.
- To install, tighten to 25 Nm (18 lb-ft).
11. Remove the fender-to-radiator grille opening panel reinforcement bolt.
- To install, tighten to 25 Nm (18 lb-ft).
12. Remove the rear lower fender bolt.
- To install, tighten to 7 Nm (62 lb-in).
13. Remove the rear upper fender bolt.
- To install, tighten to 7 Nm (62 lb-in).
14. Remove the fender upper bolts.
- To install, tighten to 7 Nm (62 lb-in).
15. Remove the fender upper rear inner bolt.
- To install, tighten to 7 Nm (62 lb-in).
16. Pull outward and upward to remove the fender.
17. To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
