2012 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE

Entertainment System Control Module: Service and Repair




Audio Control Module (ACM) Self-Diagnostic Mode

Late Build Audio Systems

NOTE: If the Audio Front Control Module (ACM) is inoperable, the ACM (Audio Front Control Module) part number may be obtained from a label affixed to the chassis.

1. Turn the ACM (Audio Front Control Module) on.

2. Operate the audio system in radio tuner (AM/FM) mode.

3. Press and hold preset buttons 3 and 6 for 3 seconds until the speaker walk test begins.
- The display indicates each speaker as it is tested.


4. NOTE: If the speaker walk test is the only test required, this procedure can be stopped after Step 3 by turning the ACM (Audio Front Control Module) off.
Before the speaker walk test is complete, carry out any of the following actions:

Factory service manual diagram




5. To exit the self-diagnostic mode, turn the ACM (Audio Front Control Module) off.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.