Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Transit Connect Electric, Van CargoFACTORY OEM SERVICE PROCEDURE
Climate Control System DTCS
PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action to Take |
|---|---|---|
| P0532 | A/C Refrigerant Pressure Sensor A Circuit Low | GO to PINPOINT TEST A . |
| P0533 | A/C Refrigerant Pressure Sensor A Circuit High | GO to PINPOINT TEST A . |
| P0645 | Air Conditioning Clutch Relay (A/CCR) Control Circuit | GO to PINPOINT TEST B . |
| P1464 | A/C Demand Out Of Self Test Range | If the HVAC selector was not in the OFF position, place it in the OFF position, CLEAR the DTCs and REPEAT the self-test. If the DTC does not return, ignore the DTC and continue diagnostics. If the DTC returns, GO to PINPOINT TEST J . |
| All Other DTCs | - | REFER to INTRODUCTION - GASOLINE MODELS . |
INSTRUMENT CLUSTER (IC) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action to Take |
|---|---|---|
| B2175 | A/C Request Signal Circuit Short to Ground | GO to PINPOINT TEST J . |
| C1779 | Blower Switch Failure | CARRY OUT the BLOWER MOTOR SWITCH . If the switch tests OK, REPAIR circuit 31S-FA26 (BK/RD) for a short to ground. TEST the system for normal operation. |
| P1459 | A/C Recirculation Switch Out of Self Test Range | GO to PINPOINT TEST D . |
| All Other DTCs | - | REFER to the Master DTC Chart in MULTIFUNCTION ELECTRONIC MODULES . |
GENERIC ELECTRONIC MODULE (GEM) DTC CHART
| DTC | Description | Action to Take |
|---|---|---|
| B1262 | Servo Motor Defrost Circuit Failure | GO to PINPOINT TEST J . |
| B1858 | Climate Control A/C Pressure Switch Circuit Failure | GO to PINPOINT TEST G . |
| B294A | Air Conditioning Switch Short to Battery | GO to PINPOINT TEST G . |
| B2960 | Air Flow Recirculation Door Open Line Driver Circuit Failure | GO to PINPOINT TEST D . |
| B2961 | Air Flow Recirculation Door Close Line Driver Circuit Failure | GO to PINPOINT TEST D . |
| All Other DTCs | - | REFER to the Master DTC Chart in MULTIFUNCTION ELECTRONIC MODULES . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
