Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Automatic Transmission Cooler: Specifications
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Transmission Fluid | |
| The use of any transmission fluid other than what is recommended for this transaxle will cause transaxle damage. Refer to MATERIAL SPECIFICATIONSÂ for the correct fluid. | |
|
NOTE:
Do not use water-based cleaners to clean or flush the transmission fluid cooler tubes or transmission damage will occur. Use only clean transmission fluid designated for this transaxle and torque converter being serviced.
|
|
MATERIAL SPECIFICATIONS
| Item | Specification | Fill Capacity | ||||
|---|---|---|---|---|---|---|
| Motorcraft® MERCON® LV Automatic Transmission Fluid XT-10-QLVC |
MERCON® LV | 10.3L (10.9 qt) (1) | ||||
| Motorcraft® MERCON® LV Automatic Transmission Fluid XT-10-QLVC |
MERCON® LV | 11.0L (11.6 qt) (2) | ||||
|
||||||
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Transmission fluid cooler thermal bypass valve nuts | 9 | - | 80 |
| Transmission fluid cooler tube bolts | 11 | - | 97 |
| Transmission fluid cooler tube fittings | 30 | 22 | - |
| Transmission fluid cooler tube retainer bolt | 6 | - | 53 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.