Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Blind Spot Monitoring DTCS
SIDE OBSTACLE DETECTION CONTROL MODULE - LEFT (SOD-L) AND SIDE OBSTACLE DETECTION CONTROL MODULE - RIGHT (SOD-R) DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description | Action |
|---|---|---|
| B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | GO to PINPOINT TEST D . |
| B11D6:15 | Driver Display Alert LED: Circuit Short To Battery Or Open | GO to PINPOINT TEST D . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | The Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control Module - Right (SOD-R) is not configured. REFER to MODULE CONFIGURATION for Programmable Module Installation (PMI) to configure the SOD-L or SOD-R. CLEAR all DTCs. TEST the system for normal operation. |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to PINPOINT TEST J . |
| U0423:00 | Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information | DTC U0423:00 is set when the SOD-L or SOD-R receives invalid network data from the IPC. RETRIEVE and REPAIR all non-network DTCs in the IPC. REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . |
| U3000:44 | Control Module: Data Failure | GO to PINPOINT TEST H . |
| U3000:45 | Control Module: Program Memory Failure | GO to PINPOINT TEST H . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | GO to PINPOINT TEST H . |
| U3000:48 | Control Module: Supervision Software Failure | GO to PINPOINT TEST H . |
| U3000:49 | Control Module: Internal Electronic Failure | GO to PINPOINT TEST H . |
| U3000:4A | Control Module: Incorrect Component Installed | GO to PINPOINT TEST H . |
INSTRUMENT PANEL CLUSTER (IPC) DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description | Action |
|---|---|---|
| U0232:00 | Lost Communication With Side Obstacle Detection Control Module Left: No Sub-Type Information | REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . |
| U0233:00 | Lost Communication With Side Obstacle Detection Control Module Right: No Sub-Type Information | REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
