2012 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE

Symptom Chart

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
Symptom Chart

Condition Possible Sources Action
  • The powertrain control module (PCM) does not respond to the scan tool, or no high speed controller area network (HS-CAN) communication
  • Fuse
  • Circuitry
  • PCM
  • Restraints control module (RCM)
  • Occupant classification sensor module
  • Four wheel drive (4WD) control module
  • Instrument cluster
  • Smart junction box (SJB)
  • The anti-lock brake system (ABS) module does not respond to the scan tool
  • Fuse
  • Circuitry
  • ABS module
  • The restraints control module (RCM) does not respond to the scan tool
  • Fuse
  • Circuitry
  • RCM
  • The smart junction box (SJB) does not respond to the scan tool
  • Fuse
  • Circuitry
  • SJB
  • The instrument cluster does not respond to the scan tool
  • Fuse
  • Circuitry
  • Instrument cluster
  • The four wheel drive (4WD) control module does not respond to the scan tool
  • Fuse
  • Circuitry
  • 4WD control module
  • No high speed controller area network (HS-CAN) communication, all modules are not responding
  • Fuse
  • Circuitry
  • PCM
  • RCM
  • Occupant classification sensor module
  • 4WD control module
  • Instrument cluster
  • SJB
  • No International Standards Organization (ISO) 9141 network communication
  • Circuitry
  • ABS module
  • No power to the scan tool
  • Fuse
  • Circuitry
  • Scan tool
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.