Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Easy Entry/Exit Feature
The easy entry/exit feature is a function of the DSM. When the ignition key is removed or for vehicles equipped with passive entry/passive start, when the button is pushed to turn the ignition off, the driver seat moves backward a maximum of 51 mm (2 in) or to the soft stop. The DSM will cancel this operation if a valid input command is received from the driver seat control switch, memory SET switch, exterior mirror control switch or steering column control switch.
The DSM will record the current seat positions before powering the seat for an easy exit operation. When the key is inserted into the ignition lock cylinder or for vehicles equipped with passive entry/passive start, the ignition button is pressed, the recorded position will be used to return the seat to the previous position during easy entry operation. Easy entry operation will be cancelled if a valid input command is received by the DSM.
The feature can be turned on/off using the message center or enabled/disabled using the scan tool under module programming. When enabled, using the scan tool, the feature becomes a user accessible item on the message center allowing the user to turn the feature on/off. Refer to the Owner's Literature or Information Center - Instrumentation, Message Center, And Warning Chimes for information on the message center.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
