Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Principles of Operation: Notes
The starter system controls the cranking of the engine. The starter motor is enabled by the starter relay when the relay is activated by the PCM . The starting system is electronically controlled by the PCM . The PCM requires the following inputs:
- Ignition switch request to start the engine
- Run/start relay voltage
- PATS enable status from the BCM
- Correct transmission PARK or NEUTRAL input from the Transmission Range (TR) sensor
Under normal operation when the ignition is turned to the START position, the BCM generates a key verification message. It sends this message to the PATS transceiver. The transceiver reads the key and sends a key verification message back to the BCM . If the message received does not match the key verified in the BCM memory, the engine is disabled and does not crank and start. Once the BCM determines the correct programmed key is in the ignition, the BCM sends the PCM a valid PATS message. When the PCM receives the message, it generates a response and sends it back to the BCM . If the response from the PCM does not match the response in the BCM memory, PATS is not enabled and the engine does not crank. If both the key verification and PCM ID pass, PATS is enabled. The PCM recognizes the correct electronically coded passive key and provides voltage and ground to the starter relay coil. The starter relay coil is energized causing the relay contacts to close providing voltage to the starter solenoid, allowing the starter motor to crank and start the engine. The PCM disengages the starter once an engine rpm threshold is reached, a set crank time is exceeded or the ignition is turned OFF. The BCM also enables the Run/start relay which sends voltage to the PCM . If the PCM does not receive this voltage the engine will not crank.
The TR sensor prevents operation of the starter motor unless the transmission is in NEUTRAL or PARK.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
