Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Section 2480 (Front Disc Brake System): Specifications
WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS
| Item | Specification | Fill Capacity |
|---|---|---|
| Motorcraft® High Performance DOT 3 Motor Vehicle Brake Fluid (US)/Motorcraft® Brake Fluid - Heavy Duty DOT 3 (Canada) PM-1-C (US); CPM-1-C (Canada) |
WSS-M6C65-A1 | 1, 420 ml (3 pt) |
| Motorcraft® Metal Brake Parts Cleaner (US)/Motorcraft® Brake Parts Cleaner (Canada) PM-4-A or PM-4-B (US); CPM-4 (Canada) |
- | - |
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Brake Disc | |
| Brake disc minimum thickness | 32 mm (1.259 in) |
| Brake Pads | |
| Brake pad maximum taper wear (in any direction) | 3.0 mm (0.118 in) |
| Brake pad minimum thickness | 3.0 mm (0.118 in) |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Brake caliper anchor plate bolts | 250 | 184 | - |
| Brake caliper flow bolt | 35 | 26 | - |
| Brake caliper guide pin bolts | 37 | 27 | - |
| Brake disc shield bolts | 18 | - | 159 |
| Brake flexible hose bracket-to-wheel knuckle bolt | 30 | 22 | - |
| Brake tube fitting | 17 | - | 150 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
