2012 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE

Section 1982 (Charging System): Specifications

WARNING: This page is about a different car, the 2012 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS

Item Specification
Generator (3.7L)Β 
Generator pulley ratio 2.69:1 (automatic transmission), 2.98:1 (manual transmission)
Rating 83 amp @ 650 rpm (min) to 156 amps @ 6, 000 rpm (max)
Voltage regulator type Electronic internal with generator
Generator (5.0L)Β 
Generator pulley ratio 2.69:1 (automatic transmission), 2.98:1 (manual transmission)
Rating (5.0L) 96 amp @ 650 rpm (min) to 156 amps @ 6, 000 rpm (max)
Voltage regulator type Electronic internal with generator
Generator (5.4L)Β 
Generator pulley ratio 2.71:1
Rating 94 amp @ 700 rpm (min) to 156 amps @ 6, 000 rpm (max)
Voltage regulator type Electronic internal with generator
TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Front End Accessory Drive (FEAD) belt tensioner bolt 25 18 -
Generator B+ terminal nut 17 - 150
Generator bolt 48 35 -
Generator clutch pulley 75 55 -
Generator stud (5.0L) 8 - 71
Generator stud nut (3.7L/5.0L) 48 35 -
Lower generator stud bolt (5.4L) 48 35 -
Power steering tube bracket nut (5.4L) 25 18 -
Stabilizer bar bracket nuts 70 52 -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.