Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Test Procedure
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- AB1 CHECK THE ENGINE OIL LEVEL
- Check that the engine oil level is correct.
Is the engine oil level correct?
Yes No REFER to NO DIAGNOSTIC TROUBLE CODES (DTCS) PRESENT SYMPTOM CHART INDEX , if a driveability concern exists. GO to AB2. - AB2 CHECK THE ENGINE OIL MAINTENANCE INTERVALS
- Check the maintenance records for engine idle time, mileage and vehicle usage since the last engine oil change. Refer to the lube oil chart in the appropriate service information article or Owner's Literature for the correct engine oil selection for temperature conditions.
Is the engine oil maintenance up to date?
Yes No GO to AB3. CHANGE the engine oil and oil filter. - AB3 CHECK THE DPF_LOAD_PCT PID STATE
- Ignition ON, engine OFF.
- Access the PCM and monitor the DPF_LOAD_PCT (PER) PID.
Is the percentage 100% or greater?
Yes No GO to AB4. ADVISE the customer of the vehicle operating conditions necessary for diesel particulate filter regeneration. - AB4 CHECK FOR AFTERMARKET PERFORMANCE PRODUCTS
- Check for aftermarket exhaust accessories and performance modifications.
Is a concern present?
Yes No RETURN the vehicle to original equipment manufacturer (OEM) components as necessary.
ADVISE the customer of the conditions that cause incomplete regeneration events.CHANGE the engine oil and oil filter.
ADVISE the customer of the conditions that cause incomplete regeneration events.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
