2012 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE

Torque Specification

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION

Description Nm lb-in
Camshaft Position (CMP) sensor bolt 10 89
Catalyst Monitor Sensor (CMS)(1) - -
Crankshaft Position (CKP) sensor bolt 10 89
Cylinder Head Temperature (CHT) sensor 10 89
Heat shield bolt and nut 10 89
Heated Oxygen Sensor (HO2S)(1) - -
Knock Sensor (KS) bolt 20 177
Mass Air Flow (MAF) sensor screws 2 18
PCM nuts 5 44
Variable Camshaft Timing (VCT) oil control solenoid bolt 10 89
(1) Refer to the procedure in this article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.