Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
General Specification Chart
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATION CHART
| Item | Specification |
|---|---|
| Power Steering Gear | |
| Turning effort | 35 N (7.86 lb) |
| Power Steering Pump | |
| Flow | 7.25-8.87L/min (1.91-2.34 gpm) Fluid @ 74°-80°C (165°-175°F) Engine @ 2,000 rpm |
| Minimum capacity | 5.0L/min (1.32 gpm) Fluid @ 74°-80°C (165°-175°F) Pressure 500 kPa (725 psi) |
| Pressure | 827 kPa (120 psi) Fluid @ 74°-80°C (165°-175°F) Engine @ 2,000 rpm |
| Relief pressure | 11.3-11.8 kPa (1,638-1,711 psi) |
| Power Steering Purge Vacuum | |
| Air purge vacuum | 68-85 kPa (20-25 in-Hg) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
