2012 Ford Taurus FWD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Check Every Six Months



Check Every Six Months

- Check lap/shoulder belts and seat latches for wear and proper operation.

- Check washer spray, wiper operation, and clean all wiper blades (replace blades as necessary).

- Check parking brake for proper operation.

- Check and lubricate all hinges, latches, door check straps and outside locks.

- Check and lubricate door rubber weatherstrips.

- Check and clean body and door drain holes.

- Check safety warning lamps (brake, ABS, air bag, safety belt) for operation.

- Check cooling system fluid level and strength.

- Check battery connections and clean if necessary.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.