2012 Ford Taurus AWD V6-3.5L TurboFACTORY OEM SERVICE PROCEDURE

Camshaft Position Sensor: Service and Repair




Camshaft Position (CMP) Sensor - 3.5L GTDI

Factory service manual diagram




NOTE: Lower radiator hose removed for clarity.

Factory service manual diagram




Factory service manual diagram




Removal and Installation

Both sensors

1. Remove the Air Cleaner (ACL) outlet pipe and the ACL (Air Cleaner).

RH sensor

2. Position the RH turbocharger intake tube aside. For additional information, refer to Intake Air System Components- Exploded View in Fuel Delivery and Air Induction.

LH sensor

3. Position the LH turbocharger intake tube aside. For additional information, refer to Intake Air System Components- Exploded View in Fuel Delivery and Air Induction.

Both sensors

4. Disconnect the Camshaft Position (CMP) sensor electrical connector.

5. Remove the bolt and the CMP (Camshaft Position) sensor.
- To install, tighten to 10 Nm (89 lb-in).


6. NOTE: Lubricate the CMP (Camshaft Position) sensor O-ring seal with clean engine oil.
To install, reverse the removal procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.