Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Mustang Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE
Exhaust System Alignment
All vehicles
NOTE:
Exhaust fasteners are of a torque prevailing design. Use only new fasteners with the same part number as the original. Torque values must be used as specified during reassembly to make sure of correct retention of exhaust components.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Loosen the muffler assembly-to-intermediate pipe ball clamps.
- Loosen the Torca® coupler nuts.
- Do not tighten the coupler at this time.
Boss® 302 only
- Loosen the exhaust side pipe-to-exhaust H-pipe nuts.
- Loosen the exhaust side pipe Torca® clamps.
5.0L and Boss® 302 only
- Loosen the catalytic converter-to-exhaust H-pipe ball clamps.
All vehicles
- Loosen the catalytic converter-to-manifold nuts.
- Do not tighten the coupler at this time.
- Position an adjustable jackstand under the catalytic converter Y-pipe/H-pipe.
- Make sure the 3 muffler assembly hooks are correctly inserted into all of the muffler exhaust isolators.
- Beginning at the front of the vehicle, align the exhaust system in the following sequence.
- Evenly tighten all 4 of the catalytic converter-to-exhaust manifold nuts (starting with the right lower, then the left lower, then the right upper, then the left upper) in 10 Nm (89 lb-in) increments until reaching the final torque of 40 Nm (30 lb-ft).
- (5.0L and Boss® 302 only) Tighten the catalytic converter-to-exhaust H-pipe ball clamp nuts to 30 Nm (22 lb-ft).
NOTE: Make sure that the intermediate pipe and converter Y-pipe/H-pipe is inserted into the Torca® coupler correctly.
NOTE:
Do not bend, twist or allow the exhaust side pipes to hang from the flexible bellows or damage to the exhaust side pipe may occur.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
