Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Focus S, Standard Trans, GasFACTORY OEM SERVICE PROCEDURE
Module Configuration and Parameter Chart
WARNING: This page is about a different variant/trim than selected.
The charts describe specific module configuration information:
ALL MODULES EXCEPT BCM AND IPC
| Module Name | Programmable Module Installation (PMI) Available | Reprogram/Flash Capable | Requires Adaptive Learning or Calibration | Available Progammable Parameters |
|---|---|---|---|---|
| ACCM | No | No | No | None |
| APIM | Yes | Yes | No | None |
| ABS module | Yes | Yes |
|
None |
| ACM | Yes | Yes | No |
|
| BECM | No | Yes | No | None |
| DC to DC Converter Control Module (DC/DC) | No | Yes | No | None |
| DDM | No | No | No | None |
| FCIM | No | No | No | None |
| GWM | Yes | Yes | No | None |
| GFM (Charge Port Light Ring) | No | No | No | None |
| GPSM | Yes | Yes | No | None |
| HVAC module | Yes | Yes | No | None |
| Image Processing Module - B (IPM-B) | Yes | Yes | No | None |
| OCSM | No | No |
|
None |
| Parking Aid Module (PAM) | Yes | Yes | No | None |
| PSCM | Yes | Yes | No | None |
| PCM | No | Yes | No | None |
| PDM | No | No | No | None |
| RFA module | Yes | Yes | No | None |
| RCM | Yes | Yes | No | None |
| SOBDM | No | Yes | No | None |
| SASM | No | No | No | None |
| TCM | No | Yes | No | None |
| TCU | Yes | Yes | No | None |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
