2012 Ford Focus ELE-Electric EngineFACTORY OEM SERVICE PROCEDURE

Front Fender: Service and Repair



Fender

Removal

1. WARNING: Before beginning any service procedure, Failure to follow this instruction may result in serious personal injury.

Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).

2. Refer to: Cowl Panel Grille.
3. Remove the cowl filler panel.


Factory service manual diagram





4. Refer to: Headlamp Assembly.
5. Refer to: Fender Splash Shield.
6. For LH fender. Refer to: Charge Port Light Ring.
7. Remove the 2 fender-to-bumper cover bolts.


Factory service manual diagram





8. Remove the 2 front fender bracket bolts.


Factory service manual diagram





9. Remove the rocker panel moulding.
Refer to: Rocker Panel Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).

10. Remove the 2 lower rear fender bracket bolts.


Factory service manual diagram





11. Remove the fender-to-A-pillar baffle.


Factory service manual diagram





12. Remove the lower A-pillar bolt.


Factory service manual diagram





13. Remove the door frame moulding.


Factory service manual diagram





14. Remove the upper A-pillar bolt.


Factory service manual diagram





15. Remove the 2 fender-to-apron bolts and the fender.


Factory service manual diagram





Installation

1. Position the fender on the vehicle and loosely install the 2 fender-to-apron bolts.


Factory service manual diagram





2. Loosely install the upper A-pillar bolt.


Factory service manual diagram





3. Loosely install the lower A-pillar bolt.


Factory service manual diagram





4. Loosely install the 2 lower rear fender bolts.


Factory service manual diagram





5. Loosely install the 2 front fender bracket bolts.


Factory service manual diagram





6. Loosely install the 2 fender-to-bumper cover bolts.


Factory service manual diagram





7. Adjust the fender to specification.
Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).

8. Tighten all fender fasteners.
Torque: 6 Nm

9. Install the door frame moulding.


Factory service manual diagram





10. Install the fender-to-A-pillar baffle.


Factory service manual diagram





11. For LH fender.
Refer to: Charge Port Light Ring (414-03B High Voltage Battery Charging System, Removal and Installation).

12. Refer to: Fender Splash Shield.
13. Install the rocker panel moulding.
Refer to: Rocker Panel Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).

14. Install the cowl filler panel.


Factory service manual diagram





15. Refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation).
16. Refer to: Cowl Panel Grille (501-02 Front End Body Panels, Removal and Installation).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.