Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Fiesta SES, Standard TransFACTORY OEM SERVICE PROCEDURE
Steering Column - Exploded View
| Item | Part Number | Description |
|---|---|---|
| 1 | W750985 | Steering wheel bolt |
| 2 | 3600 | Steering wheel |
| 3 | 3530A | Upper steering column shroud |
| 4 | 14A664 | Clockspring |
| 5 | W714630 | Lower steering column shroud screw (3 required) |
| 6 | 3530B | Lower steering column shroud |
| 7 | 13341 | Steering column multifunction switch |
| 8 | 3F791 | Steering column switch carrier |
| 9 | 17A553 | Wiper/washer switch |
| 10 | 3C529 | Steering column |
| 11 | - | Steering column anti-rotation bolt (M6 x 1 x 30) |
| 12 | 11582 | Ignition lock cylinder |
| 13 | 15607 | Passive Anti-Theft System (PATS) transceiver electrical connector (part of 14401) |
| 14 | 3F527 | Ignition switch/lock cylinder housing (push button start and key start) |
| 15 | W709942 | Ignition switch/lock cylinder housing shear bolt (or part of 3F790) |
| 16 | W520102 | Steering column nut (4 required) |
| 17 | - | Steering column module (part of 3C529) |
| 18 | 3R827A | Steering column shaft-to-steering column bolt |
| 19 | 3A525 | Steering column shaft (or part of 3C529) |
| 20 | 3R827B | Steering column shaft-to-steering gear bolt |
| 21 | 3D677 | Dash seal |
- Refer to the appropriate procedures in this service information.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
