Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Fiesta SES, Standard TransFACTORY OEM SERVICE PROCEDURE
HVAC DTCS
PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action to Take |
|---|---|---|
| P0531:2F | A/C Refrigerant Pressure Sensor A Circuit Range/Performance: Signal Erratic | INSPECT the refrigerant system for leaks. REFER to Electronic Leak Detection or Fluorescent Dye Leak Detection . If refrigerant system leaks or is low, RECHARGE the refrigerant system. Refer to SPECIFICATIONS . If the refrigerant system does not leak and is properly charged, INSTALL a new A/C pressure transducer. CLEAR the DTCs and REPEAT the self-test. TEST the system for normal operation. |
| P0532:16 | A/C Refrigerant Pressure Sensor A Circuit Low: Circuit Voltage Below Threshold | Go to Pinpoint Test A . |
| P0533:17 | A/C Refrigerant Pressure Sensor A Circuit High: Circuit Voltage Above Threshold | Go to Pinpoint Test A . |
| P0645:13 | A/C Clutch Relay Control Circuit: Circuit Open | Go to Pinpoint Test B . |
| P0646:11 | A/C Clutch Relay Control Circuit Low: Circuit Short To Ground | Go to Pinpoint Test B . |
| P0647:12 | A/C Clutch Relay Control Circuit High: Circuit Short To Battery | Go to Pinpoint Test B . |
| All Other DTCs | - | REFER to INTRODUCTION - GASOLINE MODELS . |
INSTRUMENT PANEL CLUSTER (IPC) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action to Take |
|---|---|---|
| B101E:01 | Air Conditioning Mode Switch: General Electrical Failure | PLACE the HVAC selector in the OFF position, CLEAR the DTCs and REPEAT the self-test. If the DTC does not return, ignore the DTC and continue diagnosing other DTCs or symptoms. If the DTC returns and HVAC DTC 5-2 is also set, GO to Pinpoint Test Land diagnose HVAC DTC 5-2. If the DTC returns and HVAC DTC 5-2 is not also set, INSTALL a new Instrument Panel Cluster (IPC). REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . |
| B1B71:11 | Evaporator Temperature Sensor: Circuit Short to Ground | Go to Pinpoint Test C . |
| B1B71:13 | Evaporator Temperature Sensor: Circuit Open | Go to Pinpoint Test C . |
| All Other DTCs | - | REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
