2012 Ford Fiesta SES, Standard TransFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System And Stability Control: Specifications

MATERIAL SPECIFICATIONS

Item Specification Fill Capacity
High Performance DOT 3 Motor Vehicle Brake Fluid
PM-1-C (US); CPM-1-C (Canada)
WSS-M6C62-A or WSS-M6C65-A1 630 ml
(1.33 pt)
TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
ABS module-to-Hydraulic Control Unit (HCU) screws 2 - 18
Brake tube fittings 17 - 150
Evaporator outlet tube bracket nut 8 - 71
HCU bracket bolts 24 18 -
HCU bracket-to-support plate bolts 9 - 80
HCU support plate bolts 9 - 80
Wheel speed sensor bolts 9 - 80
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.