2012 Ford Fiesta S, Standard TransFACTORY OEM SERVICE PROCEDURE

Starting System DTCS

PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
P0617:12 Starter Relay Circuit High: Circuit Short To Battery Go to Pinpoint Test C .
P0850:00 Park/Neutral Switch Input Circuit: No Sub Type Information For vehicles without Intelligent Access (IA), Go to Pinpoint Test A . For vehicles with IAΒ  , Go to Pinpoint Test B .
P0851:00 Park/Neutral Switch Input Circuit Low: No Sub Type Information For vehicles without IAΒ  , Go to Pinpoint Test A . For vehicles with IAΒ  , Go to Pinpoint Test B .
All other DTCs - REFER to ELECTRONIC ENGINE CONTROLS .
TRANSMISSION CONTROL MODULE (TCM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
P0706:00 Transmission Range Sensor A Circuit Range/Performance: No Sub Type Information REFER to AUTOMATIC SHIFTING MANUAL TRANSMISSION/TRANSAXLE .
P0707:00 Transmission Range Sensor A Circuit Low: No Sub Type Information REFER to AUTOMATIC SHIFTING MANUAL TRANSMISSION/TRANSAXLE .
P0708:00 Transmission Range Sensor A Circuit High: No Sub Type Information REFER to AUTOMATIC SHIFTING MANUAL TRANSMISSION/TRANSAXLE .
P0709:00 Transmission Range Sensor A Circuit Intermittent: No Sub Type Information REFER to AUTOMATIC SHIFTING MANUAL TRANSMISSION/TRANSAXLE .
P2801:00 Transmission Range Sensor B Circuit Range/Performance: No Sub Type Information REFER to AUTOMATIC SHIFTING MANUAL TRANSMISSION/TRANSAXLE .
P2802:00 Transmission Range Sensor B Circuit Low: No Sub Type Information REFER to AUTOMATIC SHIFTING MANUAL TRANSMISSION/TRANSAXLE .
P2803:00 Transmission Range Sensor B Circuit High: No Sub Type Information REFER to AUTOMATIC SHIFTING MANUAL TRANSMISSION/TRANSAXLE .
P2804:00 Transmission Range Sensor B Circuit Intermittent: No Sub Type Information REFER to AUTOMATIC SHIFTING MANUAL TRANSMISSION/TRANSAXLE .
All other DTCs - REFER to AUTOMATIC SHIFTING MANUAL TRANSMISSION/TRANSAXLE
REMOTE FUNCTION ACTUATOR (RFA) MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
P0615:12 Starter Relay Circuit: Circuit Short to Battery Go to Pinpoint Test C .
P1708:62 Clutch Switch Circuit: Signal Compare Failure Go to Pinpoint Test B .
All other DTCs - REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.