Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Fiesta S, Standard TransFACTORY OEM SERVICE PROCEDURE
Component testing procedure
COMPONENT TESTING PROCEDURE CHART
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Turn signal | 4 and 9 | Left turn | Closed circuit |
| Off | Open circuit | ||
| 8 and 9 | Right turn | Closed circuit | |
| Off | Open circuit | ||
| Flash-to-pass | 10 and 9 | Lever stalk in first detent toward steering wheel | Open circuit |
| 5 and 9 | Closed circuit | ||
| High beam | 10 and 9 | Lever stalk in second detent toward steering wheel | Closed circuit |
| 5 and 9 | Open circuit | ||
| Trip computer switch | 3 and 9 | Pressed | Closed circuit |
| Released | Open circuit | ||
| Voice Switch | 2 and 7 | Pressed | Closed circuit |
| Released | Open circuit |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.