Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Fiesta S, Automatic DCT TransFACTORY OEM SERVICE PROCEDURE
Inspection and Verification
This service information provides step-by-step module configuration procedures. Carry out the Programmable Module Installation (PMI) to carry out configuration or when DTCs from the list below are present:
NOTE:
Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous Memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC CHART
| DTC | Description | Source | Action |
|---|---|---|---|
| U0300 | Internal Control Module Software Incompatibility |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
| U0300:4A | Internal Control Module Software Incompatibility |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
| U2024:54 | Control Module Cal-Config Data |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
| U2050 | No Application Present |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
| U2051 | One or More Calibration Files Missing/Corrupt |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information |
|
CARRY OUT APIM programming. REFER to Accessory Protocol Interface Module (APIM) Programming . |
| U2100:55 | Initial Configuration Not Complete |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
| U2100:55 | Initial Configuration Not Complete |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information |
|
CARRY OUT APIM programming. REFER to Accessory Protocol Interface Module (APIM) Programming . |
| U3000:46 | Control Module Calibration/Parameter Memory Failure |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
| U3002:62 | Vehicle Identification Number - signal compare failure |
|
CARRY OUT PMI. REFER to Programmable Module Installation (PMI) . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.