2012 Ford Fiesta L4-1.6LFACTORY OEM SERVICE PROCEDURE

Power Window Switch: Service and Repair




Window Control Switch

NOTE: Driver window control switch shown, all others similar.

Factory service manual diagram




Factory service manual diagram




Removal and Installation

Passenger window control switch

1. Insert a non-marring tool under the window control switch bezel and pry upward.

2. Remove the window control switch from the door trim panel.

Master window control switch

3. Remove the front door trim panel. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

4. Release the window control switch retaining tabs and remove the master window control switch from the door trim panel.

All window control switches

5. Disconnect the electrical connector(s).

6. To install, reverse the removal procedure.
- The master window control switch and the LH window motor must be initialized whenever battery voltage has been removed from the driver window control switch for greater than 3 minutes (for example, the battery or the master window switch is disconnected) or if a new driver window control switch is installed. For additional information, refer to Window Motor Initialization Programming and Relearning.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.